| Description |
Wireless communications pervade all avenues of modern life. The rapid expansion of wireless services has increased the need for transmission schemes that are more spectrally efficient. Dynamic spectrum access (DSA) systems attempt to address this need by building a network where the spectrum is used opportunistically by all users based on local and regional measurements of its availability. One of the principal requirements in DSA systems is to initialize and maintain a control channel to link the nodes together. This should be done even before a complete spectral usage map is available. Additionally, with more users accessing the spectrum, it is important to maintain a stable link in the presence of significant interference in emergency first-responders, rescue, and defense applications. In this thesis, a new multicarrier spread spectrum (MC-SS) technique based on filter banks is presented. The new technique is called filter bank multicarrier spread spectrum (FB-MC-SS). A detailed theory of the underlying properties of this signal are given, with emphasis on the properties that lend themselves to synchronization at the receiver. Proposed algorithms for synchronization, channel estimation, and detection are implemented on a software-defined radio platform to complete an FB-MC-SS transceiver and to prove the practicality of the technique. FB-MC-SS is shown through physical experimentation to be significantly more robust to partial band interference compared to direct sequence spread spectrum. With a higher power interfering signal occupying 90% of its band, FB-MC-SS maintains a low bit error rate. Under the same interference conditions, DS-SS fails completely. This experimentation leads to a theoretical analysis that shows in a frequency selective channel with additive white noise, the FB-MC-SS system has performance that equals that obtained by a DS-SS system employing an optimal rake receiver. This thesis contains a detailed chapter on implementation and design, including lessons learned while prototyping the system. This is to assist future system designers to quickly gain proficiency in further development of this technology. |
